Contact
Feedback

Monitoring of dust emissions

Dust concentration and opacity in the stack emission must be measured in power plants fired by biomass CO. The exact measuring ranges and the number of components are dependent on local or national regulatory requirements and are indicated in the plant operating permit. The DUSTHUNTER SP100 dust measuring device with probe is certified for measuring very low to medium levels of dust concentration. It works on the principle of forward scattering of light.

The device features an automatic zero and reference point check and a contamination check. The DUSTHUNTER T200 measures medium to high levels of dust concentrations based on transmittance. With a contamination check on both sides, it also features an optical unit with automatic self-alignment.

  • Following product families can be used
    Product family DUSTHUNTER T200
    The type approved transmissiometer with self-alignment function
    • Integrated contamination check for sender/receiver and reflector unit
    • Automatic self-alignment of the optical assembly
    • Automatic check of zero and reference point
    • For medium to high dust concentrations
    • For small to large measuring distances
    Product family DUSTHUNTER SP100
    Probe design with forward scattered light measurement
    • One-side installation
    • For very low to medium dust concentrations
    • Automatic check of zero and reference point
    • Contamination check
    • Hastelloy probe available for corrosive gas environments
    • For small to medium duct diameters
    • Device type for hazardous area Zone 2
TOP