1) Calculation example: Pulses per revolution / measuring wheel circumference = 16,384 pulses per revolution / 200 mm = 81.92 pulses/mm.
2) Calculation example: Circumference of wheel / pulses per revolution = 200 mm / 16384 pulses per revolution = 0,012mm/pulse.
3) Value refers to the mounted encoder.
Interfaces
Communication interface
Incremental
Communication Interface detail
HTL / Push pull
Electrical data
Connection type
Cable, 8-wire, universal, 1.5 m
Power consumption max. without load
≤ 30 mA
Supply voltage
10 V ... 32 V
Load current max.
30 mA
Maximum output frequency
820 kHz
Reference signal, number
1
Reference signal, position
90°, electric, logically gated with A and B
Reverse polarity protection
✔
Short-circuit protection of the outputs
✔
MTTFd: mean time to dangerous failure
300 years (EN ISO 13849-1) 1)
1) This product is a standard product and does not constitute a safety component as defined in the Machinery Directive. Calculation based on nominal load of components, average ambient temperature 40°C, frequency of use 8760 h/a. All electronic failures are considered hazardous. For more information, see document no. 8015532.
Mechanical data
Measuring wheel circumference
300 mm
Measuring wheel surface
O-ring NBR70 1)
Mass
+ 500 g
Encoder material
Shaft
Stainless steel
Flange
Aluminum
Housing
Aluminum
Cable
PUR
Spring arm mechanism material
Spring element
Not contained in the scope of delivery of the system
Measuring wheel, spring arm
Aluminum
Start up torque
0.8 Ncm (at 20 °C)
Operating torque
0.6 Ncm (at 20 °C)
Operating speed
1,500 min⁻¹
Maximum operating speed
3,000 min⁻¹ 2)
Bearing lifetime
3 x 10^9 revolutions
Maximum travel/deflection of spring arm
40 mm
Max. permissible working area for the spring (continuous operation)
± 10 mm
Recommended spring deflection
20 mm ... 40 mm
Mounting position relative to the measuring object
Preferably from above, from below possible
1) The surface of a measuring wheel is subject to wear. This depends on contact pressure, acceleration behavior in the application, traversing speed, measurement surface, mechanical alignment of the measuring wheel, temperature, and ambient conditions. We recommend you regularly check the condition of the measuring wheel and replace as required.
2) Allow for self-heating of 3.3 K per 1,000 rpm when designing the operating temperature range.
