Mounting systems
Flexible mounting
1,433 results:
- Description: FlexFix bracket for 2 devices (e.g. sender and receiver), can be aligned ± 15°, including M5 screw
- Material: Plastic
- Details: Plastic
- Packing unit: 4 pieces
- Description: FlexFix bracket for 1 device (e.g. sender or receiver), can be aligned ± 15°, including M5 screw
- Material: Plastic
- Details: Plastic
- Packing unit: 2 pieces
- Material: Plastic
- Details: Plastic (PA6)
- Items supplied: Without mounting hardware
- Usable for: Round sensors with 6.5 mm housing diameter without fixed stop
- Material: Plastic
- Details: Plastic (PA6)
- Items supplied: Without mounting hardware
- Usable for: Round sensors with 4 mm housing diameter without fixed stop
- Description: Bracket for mounting TRANSIC on the wall
- Details: Stainless steel 1.4404
- Description: Flange with tube for combined pT probe, with cover, seal, inner diameter 70 mm, nominal length 240 mm
- Material: Structural steel 1.0037
- Details: Structural steel 1.0037
- Description: Mounting bracket for LMS5xx (for retrofitting, if 2018303 is already in use)
- Material: Stainless steel V2A (1.4301)
- Details: Stainless steel V2A (1.4301)
- Description: Housing end cap as mechanical protection for the backplane bus. Attach the housing end cap to the last module.
- Description: Omega bracket (49 mm), mounting position: face side
- Material: Aluminum
- Details: Aluminum
- Packing unit: 2 pieces
- Description: M10 steel wall plug, for floor mounting the compensation plate for device columns
- Material: Steel
- Details: Steel, zinc coated
- Packing unit: 1 piece
- Description: FlexFix mounting kit for 1 device, e.g. sender or receiver (FlexFix bracket, alignment tool and assembly materials for installation in PU3H device columns)
- Material: Plastic
- Details: Plastic
- Packing unit: 2 pieces
- Description: Sliding nut set, M5, 4x
- Packing unit: 4 pieces
- Items supplied: Included in delivery
- Description: Simple mounting bracket with protective cover. Degree of freedom in Y: 11°.
- Details: Aluminum, powder coated
- Description: Cross-slotted coupling, shaft diameter 6 mm / 6 mm, maximum shaft offset: radial ± 0.3 mm, axial ± 0.2 mm, angle ± 3°, max. speed 10,000 rpm, –10° to +80 °C, max. torque 80 Ncm, material: fiber-glass reinforced polyamide, aluminum hub
- Description: Flange with tube, inner diameter 100 mm, nominal length 240 mm
- Material: Stainless steel 1.4571
- Details: Stainless steel 1.4571
- Description: Flange with tube, inner diameter 125 mm, nominal length 500 mm
- Material: Structural steel 1.0254
- Details: Structural steel 1.0037
- Description: Flange with tube, inner diameter 125 mm, nominal length 240 mm
- Material: Structural steel 1.0254
- Details: Structural steel 1.0037