Measurement of flue gas emissions

Environmental regulations stipulate that certain pollutants in the flue gas emitted by cement plants, as well as the reference values, must be continuously monitored. In many countries, emission measuring technology must be tested for suitability, e.g., in Europe in accordance with EN15267-3, or in the US in compliance with EPA standards. SICK’s wide product portfolio for emission monitoring provides complete solutions all from one source. These include dust measuring devices from the DUSTHUNTER product family, in-situ gas analyzers such as the GM700, and extractive gas analyzer systems such as the MCS200HW and MCS100FT. Gas analyzers for special components, such as the MERCEM300Z for mercury (Hg), complete the solution portfolio. The FLOWSIC100CEMS product family provides volume flow measurement. The use of extractive or in-situ technology provides an ideal way to meet local measurement requirements.

  • Following product families can be used
    FLOWSIC100
    FLOWSIC100
    Volume flow measuring devices for continuous emission monitoring
    • Rugged titanium converters for long service life
    • Corrosion-resistant material for use with aggressive gases (option)
    • Integrated measurement via duct diameter for types H, M, and S
    • Probe version PR for cost-saving, single-sided installation in duct
    • Automated operational check with zero and reference point test
    Select
    GM700
    GM700
    Efficient process analysis – even under difficult conditions
    • High selectivity due to high spectral resolution
    • Short response times
    • No calibration required
    • No moving parts: minimal wear and tear
    • No gas sampling or conditioning required
    • Overpressure encapsulated design for ATEX Zone 2
    Select
    MCS200HW
    MCS200HW
    • Measurement of up to 10 IR components plus O2 and TOC
    • Hot/wet extractive measurement technology
    • Wear-free gas distribution through ejector pumps
    • Reference point monitoring with internal calibration cells
    • Certified digital Modbus® interface
    • Web server for platform-independent device control
    • Use of dry test gases for HCl and NH3
    Select
    MCS100FT
    MCS100FT
    • Small suitability-tested HF measuring range: 0 ... 3 mg/m³
    • Automatic spectrum adjustment via AutoVAL for reliable measured values
    • Operation via touchscreen
    • Sample gas transport by an ejector without moving parts
    • Suitability-tested according to EN15267
    • Remote control and diagnosis via SOPAS ET software
    • Automatic adjustment of the analyzer
    • Automatic backwashing and filter cleaning of the extraction unit
    Select
    DUSTHUNTER SP100
    DUSTHUNTER SP100
    • Installation from one side
    • For very low to medium dust concentrations
    • Automated check of zero and reference point
    • Contamination check
    • Hastelloy measuring probe available for corrosive gases
    • For small to medium duct diameters
    • Device version for explosive zone 2/22 or 1/21
    Select
    MERCEM300Z
    MERCEM300Z
    • Accurate measurement of “total mercury” directly in a thermal converter (patented)
    • Measuring operation without reagents
    • Practically maintenance-free gas sampling using an ejector pump – no moving parts
    • Integrated adjustment cell for automated drift checking
    • Automated adjustment of the entire measuring system with a built-in test gas generator (optional)
    • Completely modular system design
    Select