Mounting systems
1,438 results:
- Material: Plastic
- Details: Plastic (PA6)
- Items supplied: Without mounting hardware
- Usable for: Round sensors with 4 mm housing diameter without fixed stop
- Description: FlexFix bracket for 1 device (e.g. sender or receiver), can be aligned ± 15°, including M5 screw
- Material: Plastic
- Details: Plastic
- Packing unit: 2 pieces
- Description: FlexFix bracket for 2 devices (e.g. sender and receiver), can be aligned ± 15°, including M5 screw
- Material: Plastic
- Details: Plastic
- Packing unit: 4 pieces
- Description: Bracket for mounting TRANSIC on the wall
- Details: Stainless steel 1.4404
- Description: Mounting bracket for integrated profile cylinder/tie-rod cylinder
- Material: Zinc diecast
- Details: Zinc diecast
- Items supplied: Mounting hardware included
- Description: Flange with tube for combined pT probe, with cover, seal, inner diameter 70 mm, nominal length 240 mm
- Material: Structural steel 1.0037
- Details: Structural steel 1.0037
- Description: Weather proof cover for analyzer, does not cover purge air attachment
- Description: QuickFix bracket for 1 device (e.g. sender or receiver)
- Material: Plastic
- Details: Plastic
- Packing unit: 2 pieces
- Description: Mounting bracket for LMS5xx (for retrofitting, if 2018303 is already in use)
- Material: Stainless steel V2A (1.4301)
- Details: Stainless steel V2A (1.4301)
- Description: Aluminium measuring wheel with O-ring (NBR70) for 6 mm solid shaft, circumference 200 mm
- Description: Collet for through hollow shaft, shaft diameter 12 mm, outer diameter 14 mm
- Description: Collet for blind hollow shaft, shaft diameter 3/8 (9.525 mm), outer diameter 15 mm
- Description: Collet for blind hollow shaft, shaft diameter 1/2 (12.7 mm), outer diameter 15 mm
- Description: Omega bracket (49 mm), mounting position: face side
- Material: Aluminum
- Details: Aluminum
- Packing unit: 2 pieces
- Description: Omega bracket (30 mm), mounting position: face side
- Material: Aluminum
- Details: Aluminum
- Packing unit: 2 pieces
- Description: Omega bracket (24 mm), mounting position: face side
- Material: Aluminum
- Details: Aluminum
- Packing unit: 2 pieces
- Description: Adjusting plate for floor mounting of device columns, height 3 mm
- Material: Steel
- Details: Steel
- Description: M10 steel wall plug, for floor mounting the compensation plate for device columns
- Material: Steel
- Details: Steel, zinc coated
- Packing unit: 1 piece
- Description: Snap-on front screen protection set (protects sensors from damage by flying sparks and welding beads)
- Packing unit: 2 pieces
- Items supplied: Mounting hardware included