Mounting systems
Flexible mounting
1,353 results:
- Material: Plastic
- Items supplied: Without mounting hardware
- Usable for: Round sensors with 6.5 mm housing diameter without fixed stop
- Material: Plastic
- Items supplied: Without mounting hardware
- Usable for: Round sensors with 5 mm housing diameter without fixed stop
- Material: Plastic
- Items supplied: Without mounting hardware
- Usable for: Round sensors with 4 mm housing diameter without fixed stop
- Material: Plastic
- Items supplied: Without mounting hardware
- Usable for: Round sensors with 3 mm housing diameter without fixed stop
- Description: Alignment bracket for scanGrid2, can be aligned ± 10°
- Suitable for: scanGrid2
- Description: Compact FlexFix bracket for 1 device (e.g. sender or receiver), can be aligned ± 15°, including M5 screw, for mounting with countersunk screws
- Material: Plastic
- Packing unit: 2 pieces
- Description: Compact FlexFix bracket for 2 devices (e.g. sender and receiver), can be aligned ± 15°, including M5 screw, for mounting with countersunk screws
- Material: Plastic
- Packing unit: 4 pieces
- Description: Mounting bracket for integrated profile cylinder/tie-rod cylinder
- Material: Zinc diecast
- Items supplied: Mounting hardware included
- Description: Flange with tube for combined pT probe, with cover, seal, inner diameter 70 mm, nominal length 240 mm
- Material: Structural steel 1.0037
- Description: Weather proof cover for analyzer, does not cover purge air attachment
- Description: Flange with tube, inner diameter 70,2 mm, nominal length 240 mm, material = 1.0037
- Material: Structural steel 1.0037
- Description: Mounting bracket for LMS5xx (for retrofitting, if 2018303 is already in use)
- Material: Stainless steel V2A (1.4301)
- Description: Aluminium measuring wheel with O-ring (NBR70) for 6 mm solid shaft, circumference 200 mm
- Description: Aluminium measuring wheel with O-ring (NBR70) for 10 mm solid shaft, circumference 200 mm
- Description: Housing end cap as mechanical protection for the backplane bus. Attach the housing end cap to the last module.
- Description: Collet for through hollow shaft, shaft diameter 10 mm, outer diameter 14 mm
- Description: Collet for through hollow shaft, shaft diameter 12 mm, outer diameter 14 mm
- Description: Collet for blind hollow shaft, shaft diameter 3/8 (9.525 mm), outer diameter 15 mm